Painted Die-Cast "Stomp Box" Enclosures 1590-STOMP Series

WARNING:  Many websites sell knockoffs and copies using Hammond part numbers, or “similar to Hammond."  Make sure it says Hammond!

Key Features

• Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument enclosure.
• Factory powder coated to save stomp box manufacturers and experimenters time & money. 
• Coated with a smooth gloss polyester powder coat for a lasting finish, even after machining.
• Smooth finish allows for easy adhesion of labels and/or silk screens.
• Colors are matched to standard RAL colors (see table below).
• Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
• Unfinished & textured black version is also available & in many other sizes and styles - See "Die-Cast Aluminum”  and “Trapezoid & Octagon Die-Cast"
• Designed to meet IP54.  See gasket kit accessory below to meet IP65.  IP65 rating also requires water-tight screws.
• Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.

Replacement Hardware

• Replacement screws - nickel plated, 6-32 x 1/2” - 1590MS100 - Package of 100. 
• For an even funkier look - order our black replacement screws, 6-32 x 1/2” - 1590MS50BK - Package of 50

Tamper-Resistant Hardware (Upgrade!)

• Tamper-resistant screws - nickel plated, 6-32 x 1/2” - 1590MS50T - Package of 50.
• For an even funkier look - order our black replacement screws, 6-32 x 1/2” - 1590MS50TBK - Package of 50

Photo Features:

Hammond stomp box enclosures come in traditional sizes and shapes and well as unique trapezoid and octagon models.