Type 4X, 6P Polycarbonate & General Purpose ABS Enclosures 1555 Series

Key Features

• Ideally suited for mounting printed circuit boards or DIN rail mounted components.
• Styled lid version provides a smooth, recessed surface on lid for a membrane keypad or label.
• Standoffs molded in the interior of the lid (except for sizes "A" and “B”).  Designed for #6 self tapping screws.
• Enclosure color is a light gray (RAL 7035).
• Gasketed lid with two piece tongue and groove construction provides protection against access of oil, dust, and water.
• Replaceable gasket is one piece made from high temperature UL listed silicone.  Supplied loose inside the enclosure (not pre-installed).
• Lid is secured with included M4 stainless steel machine screws which are threaded into corrosion resistant bushings for repetitive assembly & disassembly.  All hardware is designed to avoid corrosion caused by harsh environments over time. 
• Lid screws are self captivating. Lid holes are threaded with the first installation of lid screws.
• Internal features are maximized for mounting options and vary with size:
  • Internal DIN rail mounting tabs molded into most models, except sizes “C” and “D”.
  • Threaded (M3) integral brass inserts and/or standoffs (for #6 self tapping screws) for PC board or inner panel mounting in all but the smallest sizes ("A" and “B”). 
  • Vertical PC card guides (for 1.5 mm thick P.C. boards) are molded in all but the smallest sizes ("A" and “B”).

Ratings:

ABS

• ABS versions are molded from general purpose material which carries a flammability rating of UL94-HB.  For indoor use.
• ABS versions are not UL listed but have been tested to and meet IP66 ratings.
• ABS versions carry an impact rating of IK07 per IEC 62262:2021.
• Recommended operating temperature: -20°C to +60°C (-4°F to +140°F).

Polycarbonate

• Polycarbonate versions are UV stabilized for outdoor use.  Gray polycarb carries a UL94-5VA rating, while clear and smoked lids carry a UL94V-0 rating.
• Polycarbonate versions are cUL and UL 508A listed under file #E65324. 
• Polycarbonate versions have been independently tested to meet IP66, IP67, and IP68 as well as NEMA Type 4, 4X, 6, 6P, 12 & 13 ratings.
  • Exception: 1555VGY and 1555V2GY are Type 4, 4X only.
• Polycarbonate versions carry an impact rating of IK08 per IEC 62262:2021.
• Recommended operating temperature: -40°C to +110°C (-40°F to +230°F).
  • Customers should conduct their own testing to determine suitability for any specific application.

---

Photo Features:

---

Videos

Accessories

• Inner Panels
• Replacement Gaskets
• Pole Mount Kit
• Pressure Compensation Plug
• Breather Kit
• Small Rainproof Ventilator
• Liquid-Tight, Strain Relief Cordgrips
• Hole Plugs