ABS Plastic Instrument Enclosures 1598R Series

Key Features:

• Desk top electronic instrument enclosure, ideally suited for mounting printed circuit boards.
• Molded from flame retardant ABS plastic (material carries a UL flammability rating of 94V-0).
• Interior of each enclosure half is specially masked and sprayed with an RFI/EMI copper conductive coating (see close up photo below).
• Coating manufacturer specifies an attenuation of more than 75 db from 1 Mhz. to 1 Ghz.
• Designed to meet IP54.
• Two sets of vertical 1.5 mm (0.062”) P.C. board guides are molded into case halves front and rear.
• Front and rear panels are 1.6 mm (0.064”) brushed aluminum with protective paper on one side.
• Cases halves are secured with M3 x 0.5” x 10 mm (0.39”) Phillips machine screws threaded into tapped integral brass bushings. Perfect for applications with repetitive assembly and disassembly are required.
• Integral horizontal P.C. card mounts on Eurocard centers.
• P.C. card standoffs molded into top & bottom half of enclosure - require #6 x 1/4” (6.4mm) screws - part number 1598ATS100
• Stocked in matte textured black.

Alternative:

• When shielding is not required, try series 1598