ABS Plastic Hand Held Enclosures RH Series

Key Features:

• Electronic hand held enclosures, ideally suited for mounting printed circuit boards.
• Ergonomically designed for a comfortable fit into the user’s hand.
• Lap joint construction provides protection against dust accumulation and splashing water.
• Available in two versions - gasketed (IP65 rated) & no gasket.
• Gasketed version includes gasket around top & bottom half and around battery door (factory installed).
• Molded in a general purpose ABS plastic with a light texture (material carries a UL flammability rating of UL94 HB).
• The top half includes a smooth recessed area for membrane, label or silkscreen.
• Assembled with M3 Philips self tapping screws.
• Both top and bottom halves contain P.C. board standoffs molded in (see photos for details).

Photos:

Non-gasketed version

Gasketed version

Assembled

Belt Clips:

• Choice of either black or grey (to match above enclosures)
• Made from tough nylon material
• Includes mounting hardware